Analysis Of Baby Incubator Humidity Based PID with Kangaroo Mode
Abstract
The main factor that affects the parameters of the workings of humidity in the baby incubator is the sensor used to read the humidity in the room. The purpose of this study is to analyze the humidity sensor in the baby incubator using 2 humidity sensors (DHT11 and DHT22) in the different location. The manufacture of this device used an after-only design, with a comparison device of INCU Analyzer, DHT11, and DHT22 sensors. Based on the measurement, DHT11 produced a value of 46%, while DHT22 produced a value of 55.45% with BPFK standards of 50%-70%. Based on the results of measurements using the INCU Analyzer, the average error value for DHT11 is 16.05%, while DHT22 is 3.47%. Therefore, the results showed that the DHT22 sensor was more accurate to be used in baby incubators because the measurement results were under BPFK standards and produced a low error value. This can be further implemented in a baby incubator making to improve the health and safety of the babies
Downloads
References
R. Sutan and S. Berkat, “Does cultural practice affects neonatal survival-a case control study among low birth weight babies in Aceh Province, IndonesiaSutan, R., & Berkat, S. (2014). Does cultural practice affects neonatal survival-a case control study among low birth weight bab,” BMC Pregnancy Childbirth, vol. 14, no. 1, pp. 1–13, 2014.
J. A. J. J. P. Melati, “Kangaroo Mother Care at Low Birth Weight,” Asian J. Appl. Sci. (ISSN 2321–0893), vol. 8, no. 01, 2020.
R. Tessier et al., “Kangaroo Mother Care: A method for protecting high-risk low-birth-weight and premature infants against developmental delay,” Infant Behav. Dev., vol. 26, no. 3, pp. 384–397, 2003.
M. Leneuve-Dorilas, A. Favre, G. Carles, A. Louis, and M. Nacher, “Risk factors for premature birth in French Guiana: the importance of reducing health inequalities,” J. Matern. Neonatal Med., vol. 32, no. 8, pp. 1388–1396, 2019.
I. Sharma and M. Singh, “Infant Warmer Design with PID Control for Stability and Equal Temperature Distribution Equipped with Digital Scales for Prevention of Hypothermia in Newborns,” Int. J. Adv. Heal. Sci. Technol., vol. 1, no. 1, pp. 7–13, 2021.
M. Muliani and L. Lisnawati, “The Effect of Kangaroo Mother Care Method toward Weight Gain and Length of Stay among Low Birth Weight Baby,” Int J Public Heal Sci, vol. 7, no. 2, p. 91, 2018.
A. S. Jagadish, A. Benakappa, N. Benakappa, and G. Morgan, “A randomized control trial of hypothermia alert device in low birth weight newborns and the effect on kangaroo mother care and weight gain,” Int. J. Contemp. Pediatr, vol. 7, pp. 52–56, 2019.
M. Evereklian and B. Posmontier, “The Impact of Kangaroo Care on Premature Infant Weight Gain,” J. Pediatr. Nurs., vol. 34, pp. e10–e16, 2017.
D. S. T. Trisuciyani, I. Bayi, S. Skin, and L. Belakang, “Modifikasi inkubator bayi dilengkapi kontrol kelembaban,” Modif. inkubator bayi dilengkapi kontrol kelembaban, 2015.
S. Rizqy Rully Pratama, Torib Hamzah, “Infant Incubator (Monitoring Skin, Kontrol Suhu Ruang, Monitoring Kelembaban),” Kazoku syakaigaku kenkyu, vol. 28, no. 2, pp. 250–250, 2016.
M. J. Al’Aziz, B. G. Irianto, and A. Kholiq, “Infant Warmer Equipped with Digital Weight Scales,” J. Teknokes, vol. 14, no. 2, pp. 68–72, 2021.
S. Alduwaish et al., “Automated Humidity Control System for Neonatal Incubator,” in Journal of Physics: Conference Series, 2021, vol. 2071, no. 1, p. 12029.
D. Nofitasari, I. D. G. H. Wisana, T. Triwiyanto, E. D. Setioningsih, M. R. Mak’ruf, and P. C. Nugraha, “A low-cost Holter monitor design equipped with external memory and Bluetooth connection,” IOP Conf. Ser. Mater. Sci. Eng., vol. 850, no. 1, 2020.
A. Latif, H. A. Widodo, R. A. Atmoko, T. N. Phong, and E. T. Helmy, “Temperature and Humidity Controlling System for Baby Incubator,” J. Robot. Control, vol. 2, no. 3, pp. 190–193, 2021.
S. J. Hammoodi, K. S. Flayyih, and A. R. Hamad, “Design and implementation speed control system of DC motor based on PID control and matlab simulink,” Int. J. Power Electron. Drive Syst., vol. 11, no. 1, p. 127, 2020.
D. B. Zimmer, A. A. P. Inks, N. Clark, and C. Sendi, “Design, Control, and Simulation of a Neonatal Incubator,” in 2020 42nd Annual International Conference of the IEEE Engineering in Medicine & Biology Society (EMBC), 2020, pp. 6018–6023.
M. S. A. Nampira and A. Kholiq, “A Modification of Infant Warmer with Monitoring of Oxygen Saturation, Heart Rate and Skin Temperature,” J. Electron. Electromed. Eng. Med. Informatics, vol. 3, no. 1, pp. 19–25, 2021.
N. A. I. Farola, H. Gumiwang, and S. Sumber, “Nine Channel Temperature Data Logger in Measuring the Effectiveness of the Sterilization Process of Medical Instruments with Dry Sterilization,” Int. J. Adv. Heal. Sci. Technol., vol. 1, no. 1, pp. 26–33, 2021.
S. Sendra, P. Romero-Díaz, J. Navarro-Ortiz, and J. Lloret, “Smart infant incubator based on LoRa networks,” in 2018 IEEE/ACS 15th International Conference on Computer Systems and Applications (AICCSA), 2018, pp. 1–6.
A. G. Shabeeb, A. J. Al-Askery, and Z. M. Nahi, “Remote monitoring of a premature infants incubator,” Indones. J. Electr. Eng. Comput. Sci., vol. 17, no. 3, pp. 1232–1238, 2020.
R. Rocha Ribeiro, E. Bauer, and R. Lameiras, “HIGROTERM: An Open-Source and Low-Cost Temperature and Humidity Monitoring System for Laboratory Applications,” Inventions, vol. 6, no. 4, p. 84, 2021.
N. Omar, H. Zen, N. N. A. A. A. Aldrin, W. Waluyo, and F. Hadiatna, “Accuracy and Reliability of Data in IoT System for Smart Agriculture,” Int. J. Integr. Eng., vol. 12, no. 6, pp. 105–116, 2020.
S. H. W. S. S. Kusumastuti, E. Supriyanto, and I. D. Putri, “Sensor Data Analysis On Monitoring And Control System Of Temperature And Humidity Based On Android In Soybean Seed Storage Room Using Nodemcu.”
M. M. Wurfel, “Temperature and Humidity Module,” Aosong Guangzhou Electron. Co., Ltd, pp. 1–9, 2018.
T. Liu, “Digital-Output relative humidity & temperature sensor/module DHT22,” New York Aosong Electron., vol. 22, pp. 1–10, 2015.
J. M. Barcelo-Ordinas, J. Garcia-Vidal, M. Doudou, S. Rodrigo-Muñoz, and A. Cerezo-Llavero, “Calibrating low-cost air quality sensors using multiple arrays of sensors,” in 2018 IEEE Wireless Communications and Networking Conference (WCNC), 2018, pp. 1–6.
G. Korotcenkov, Handbook of humidity measurement, volume 2: Electronic and electrical humidity sensors. CRC Press, 2019.
Copyright (c) 2022 Singgih Yudha Setiawan, Dwi Herry Andayani, Andjar Pudji, Liliek Soetjiatie, Alievya Brillianty Anugrah Kusuma
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution-ShareAlikel 4.0 International (CC BY-SA 4.0) that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
.png)
.png)
.png)
.png)
.png)
