Design And Fabrication of Temperature and Humidity Stabilizer on Low Voltage Distribution Panel with PLC-Based Fuzzy Method to Prevent Excessive Temperature and Humidity on The Panel

  • Anggara Trisna Nugraha Shipbuilding Institute of Polytechnic Surabaya, Indonesia
  • Reza Fardiyan As'ad Shipbuilding Institute of Polytechnic Surabaya, Indonesia
  • Adianto Shipbuilding Institute of Polytechnic Surabaya, Indonesia
  • Vugar Hacimahmud Abdullayev Azerbaijan State Oil and İndustry University
DOI: https://doi.org/10.35882/jeeemi.v4i3.241
Keywords: Distribution Panel, Temperature, Humidity, Fuzzy Method

Abstract

Distribution panel is equipment that functions to receive electrical energy from PLN and subsequently distributes, as well as controls the distribution of electrical energy through the main and branch panel circuits to branch Distribution Panel or directly through the final load circuit. One of the problems with the Distribution Panel is the occurrence of fluctuating voltage changes and disturbances caused by condensation due to high humidity values. Based on previous research, the solution to minimize this problem is by optimizing the temperature and humidity on the Distribution Panel. So, in this research, we examine the effect of fan and heater control on the temperature and humidity of the Distribution Panel. The aim of this research is to fabrication the prototype that can be prevent the presence of excess temperature and humidity that does not meet applicable standards. So that it is expected to minimize the occurrence of hazards due to excessive temperature and humidity. In this research, it was found that the fan control using the fuzzy method can change the temperature of the panel room from 42.06oC to 32.82oC in a period of 440 seconds. However, the fan control with simple logic can only change the temperature of the panel room which is all 42.22oC to 35.05oC in 440 seconds. So it can be concluded that the fan control with the fuzzy method can reduce the temperature faster than the fan control with simple logic. Based on the graph on the panel room temperature stability test, it was found that the level of temperature stability in the room could be better controlled with fan control with the fuzzy method than using fan control with simple logic. Heater control system can reduce humidity levels from 95.14%RH to 55.25%RH within 160 seconds.

Downloads

Download data is not yet available.

References

W. Z. Leow, Y. M. Irwan, M. Irwanto, M. Isa, A. R. Amelia, and I. Safwati, “Temperature distribution of three-dimensional photovoltaic panel by using finite element simulation,” Int. J. Adv. Sci. Eng. Inf. Technol., vol. 6, no. 5, pp. 607–612, 2016.

R. I. Sudjoko, Hartono, Suhanto, Kustori, S. Hariyadi, and F. Faizah, “Design and Control Motorized Circuit Breaker in Electrical Distribution Panel,” J. Phys. Conf. Ser., vol. 2117, no. 1, 2021.

T. Wati, A. Sahrin, T. Suheta, and I. Masfufiah, “Design and Simulation of Electric Center Distribution Panel Based on Photovoltaic System,” IOP Conf. Ser. Mater. Sci. Eng., vol. 462, no. 1, 2019.

W. M. N. Surawimala and J. B. Ekanayake, “Assessing the service condition of an electrical panel board,” Ceylon J. Sci., vol. 48, no. 2, p. 113, 2019.

N. Joksch, Design of Improved Distribution Panel for the DC House By, no. June. 2013.

B. Setiawan, F. Ronilaya, D. K. P. Aji, A. Setiawan, and E. S. Putra, “Online monitoring and data logging power quality parameters of Low Voltage Distribution Panel (LVDP) on industrial system,” IOP Conf. Ser. Mater. Sci. Eng., vol. 830, no. 3, pp. 1–8, 2020.

Y. Su, Z. Xie, L. Li, Y. Lu, and J. Wang, “Analysis of Internal Heat Transfer Characteristics of High voltage Switch Cubicle Heating Fault,” IOP Conf. Ser. Earth Environ. Sci., vol. 508, no. 1, 2020.

A. R. Amelia et al., “Cooling on Photovoltaic Panel Using Forced Air Convection Induced by DC Fan,” Int. J. Electr. Comput. Eng., vol. 6, no. 2, p. 526, 2016.

M. D. Thakor, S. K. Hadia, and A. Kumar, “Precise temperature control through Thermoelectric Cooler with PID controller,” in 2015 International Conference on Communications and Signal Processing (ICCSP), 2015, pp. 1118–1122.

S. Ponnusamy, R. Samikannu, B. A. Tlhabologo, W. Ullah, and S. Murugesan, “Design and development of microcontroller-based temperature monitoring and control system for power plant generators,” IOP Conf. Ser. Mater. Sci. Eng., vol. 1055, no. 1, p. 012158, 2021.

G. Shahgholian, M. Maghsoodi, M. Mahdavian, M. Janghorbani, M. Azadeh, and S. Farazpey, “Analysis of speed control in DC motor drive by using fuzzy control based on model reference adaptive control,” in 2016 13th International Conference on Electrical Engineering/Electronics, Computer, Telecommunications and Information Technology (ECTI-CON), 2016, pp. 1–6.

J. Z. Moro, L. F. C. Duarte, E. C. Ferreira, and J. A. S. Dias, “A Home Appliance Recognition System Using the Approach of Measuring Power Consumption and Power Factor on the Electrical Panel, Based on Energy Meter ICs,” Circuits Syst., vol. 04, no. 03, pp. 245–251, 2013.

Badan Standarisasi Nasional, Persyaratan Umum Instalasi Listrik (PUIL) 2011. Jakarta: Badan Standarisasi Nasional, 2011.

H. . Zondag, D. W. de Vries, and A. van Steenhoven, “Thermal and electrical yield of a combi-panel, in: Proceedings of ISES Bi-annual Conference on CD-ROM, Jerusalem,” Proc. ISES Bi-annual Conf., 2013.

Badan Standarisasi Nasional, Persyaratan Umum Instalasi Listrik (PUIL) 2000. Jakarta: Badan Standarisasi Nasional, 2000.

D. Despa, F. X. A. Setyawan, G. F. Nama, and J. Delano, “Artificial Neural Network Applications Use Measurements of Electrical Quantities to Estimate Electric Power,” J. Phys. Conf. Ser., vol. 1376, no. 1, 2019.

A. Machniewicz, D. Knera, and D. Heim, “Effect of transition temperature on efficiency of PV/PCM panels,” Energy Procedia, vol. 78, pp. 1684–1689, 2015.

S. B. Mandal, M. D. Nerkar, and A. R. Deshbhratar, “Electric Transformation Distribution Panel ( DP ) Maintenance Using Android Application,” vol. 2, no. 12, pp. 20–23, 2021.

D. Li, Q. Qin, and X. Yang, “Application of model-free adaptive temperature control in medium frequency induction heating,” J. Phys. Conf. Ser., vol. 2170, no. 1, 2022.

I. A. Rahardjo, M. Subekti, and I. Wahyudi, “Analysis of Blackouts Based on the Medium Voltage Distribution Network’s Disruptions Time in UP3 Menteng Central of Jakarta,” J. Phys. Conf. Ser., vol. 1737, no. 1, pp. 6–10, 2021.

PT. PLN, Perangkat Hubung Bagi Tegangan Menengah. Jakarta Selatan: PT. PLN (Persero), 2019.

X. Li, “Application Research of Power System Automation Based on Electrical Automation Technology,” J. Phys. Conf. Ser., vol. 1881, no. 2, 2021.

G. Yang and M. Xu, “Research on Application of Distribution Automation Terminal Equipment Based on Smart Grid in Power Distribution Automation,” J. Phys. Conf. Ser., vol. 1345, no. 5, 2019.

A. V. Romodin, D. Y. Leyzgold, S. V. Mishurinskikh, N. V. Pavlov, and A. S. Semenov, “Development of methods for modeling of oil and gas producing enterprises electrotechnical complexes,” J. Phys. Conf. Ser., vol. 1886, no. 1, 2021.

M. Meng and W. Zhang, “Innovative Application of Electrical Automation Technology in Power Dispatching under the Environment of Energy Saving and Emission Reduction,” IOP Conf. Ser. Earth Environ. Sci., vol. 450, no. 1, 2020.

Nurhidayah, M. Peslinof, M. F. Afrianto, F. Deswardani, T. Restianingsih, and J. Pebralia, “Design of controlled temperature test in biochar production furnace automation,” J. Phys. Conf. Ser., vol. 1816, no. 1, 2021.

Sensirion AG, “Digital Humidity Sensor SHT2x (RH/T),” Online, 2014. [Online]. Available: http://www.sensirion.com/en/01_humidity_sensors/05_humidity_sensor_sht21/00_humidity_sensor_sht21.html. [Accessed: 27-Nov-2021].

M. Gu, “Study on optimum temperature value setting for the heat-setting process based on PSO,” IOP Conf. Ser. Earth Environ. Sci., vol. 69, no. 1, 2017.

M. R. B. Khan, R. Jidin, J. Pasupuleti, and S. A. Shaaya, “Building automation: Photovoltaic assisted thermal comfort management system for energy saving,” IOP Conf. Ser. Earth Environ. Sci., vol. 16, no. 1, 2013.

B. A. Fadheel, A. J. Mahdi, H. F. Jaafar, M. S. Nazir, M. S. Obaid, and S. H. Musa, “Speed Control of a Wheelchair Prototype Driven by a DC Motor Through Real EEG Brain Signals,” IOP Conf. Ser. Mater. Sci. Eng., vol. 671, no. 1, 2020.

Handson Technology, “L298N Dual H-Bridge Motor Driver,” Handson Technology, 2019. [Online]. Available: https://handsontec.com/index.php/product/l298n-dual-h-bridge-dc-motor-driver-module/. [Accessed: 03-Dec-2021].

Published
2022-07-28
How to Cite
[1]
A. T. Nugraha, R. F. As’ad, Adianto, and V. H. Abdullayev, “Design And Fabrication of Temperature and Humidity Stabilizer on Low Voltage Distribution Panel with PLC-Based Fuzzy Method to Prevent Excessive Temperature and Humidity on The Panel”, j.electron.electromedical.eng.med.inform, vol. 4, no. 3, pp. 170-177, Jul. 2022.
Issue
Vol 4 No 3 (2022): July
Section
Research Paper

Copyright (c) 2022 Reza Fardiyan As'ad, Anggara Trisna Nugraha, Adianto, Vugar Hacimahmud Abdullayev

Creative Commons License

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

Authors who publish with this journal agree to the following terms:

  1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution-ShareAlikel 4.0 International (CC BY-SA 4.0) that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
  2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
  3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).